LightRail 4.20 AdjustaDrive w/ Add a Lamp Kit + pre-installe

LR42KT
$419.99

LightRail 4.20 AdjustaDrive Kit comes complete with a variable speed LightRail 4.0 AdjustaDrive Motor, a two-piece 2 meter (6’6”) Rail, an Add A Lamp Kit with another 2-meter Rail, Push/Pull Rod, Auxiliary Trolley, instructions and hardware for moving two lights with the enclosed Motor. In addition, this indoor grow Kit comes with pre-installed Extreme Duty Trolley Wheels rated to 60 lbs, and these wheels have a lifetime warranty! Move two lights along 4 meters (12’) of Rail and all from one Kit box – the LightRail 4.20 – With both a 0 to 60 second adjustable time delay for promoting even growth from end to end plus the added feature of two to four feet per minute adjustable speed control that covers a wide range of lamp intensities and travel distances, LightRail 4.20 is great for customers who want that additional control. LightRail 4.20 will move any grow lights/ any hoods, multiple sizes and weights and is a scalable system where up to three indoor grow lights can move in-line with the use of one Motor. LightRail is just right for any indoor grow equipment set up including indoor grow light systems, seasonal greenhouse lighting, all season greenhouse grow lights, grow tent set ups and commercial grower facilities.

11.0 lbs.
6.0L x 7.0W x 42.0H
120/240

How much weight can the Light Rail 5.0 carry?

The Light Rail 5.0 can support up to 100 lbs. when mounted properly. Note: the greater the weight, the more frequently trolley wheels will need to be replaced.

What if my Sola Rola travels beyond the magnetic stops?

It needs to be resynchronized. First, remove power from the system. Next, remove the magnets from the track. Then, repeat the process for installing the magnetic stops as listed previously in the manual. Make sure the rails are installed at least 6"

My digital 7-day timer won't come on at my programmed time. Is it defective?

First, make sure it is in Auto mode (the screen says AUTO at the bottom). If that doesn't help, the timer might be in Random mode. Press the WEEK and HOUR buttons simultaneously to toggle Random mode on and off (you'll see a circle appear and disappear on

I'm having trouble programming the digital 7-day timer TM01715(D). Is there an alternate set of instructions?

Step 1: Press PROG. Left side of screen should display 1 ON. Step 2: Press WEEK until the desired week schedule is displayed at top of screen. Step 3: Press HOUR and MIN to set the desired time you want the timer to turn the device on. Step 4: Press

How many lights can I plug into a lighting controller that is wired to 120V?

Running your lights at 120V (instead of 240V) will reduce the acceptable amount of ballasts used by half. For example, an 8 light controller, when wired to 120V, can only have a maximum of four 1000W ballasts plugged in. This is because the amperage drawn

How much weight can the Light Rail 3.5 and 4.0 carry?

If mounted continuously along the rail through all the mounting holes first to a board, and then the board to the ceiling, it will easily carry 75 lbs as long as the board is mounted sufficiently to a structure that will handle the weight. If mounted only

Will this ballast work with a flip box?

If you are using a "Flip Relay Box" and your ballasts are having trouble switching, you must observe the following instructions to ensure proper operation. Most electronic ballasts contain an "error sensing" open circuit safety feature

How do I re-attach my Hydrofarm Light Track trolly to the chain?

The Hydrofarm Light Track has a small pin that attaches the trolly to the chain. There is one link in the chain that is big enough to fit the pin. Refer to the above PDF for a closer look.